Product Description
Note: The relay is a passive output, it only acts as a switch and does not output any electricity!
The following accessories are also required to purchase this item:
M3 copper column, screwdriver, switching power supply, switching power supply module, double-ended DuPont line
Module description
1. The module adopts genuine high-quality relay, the maximum load of the normally open interface: AC 250V/10A, DC 30V/10A
2. Using patch optocoupler isolation, strong driving ability, stable performance, trigger current 5A
3. Module working voltage: 3V 5V 12V 24V
4. The module can be triggered by low level setting by jumper
5. Fault-tolerant design, even if the control line is broken, the relay will not act
6. Power indicator (green), relay status indicator (red)
7. The interface design is user-friendly, all interfaces can be directly connected through the terminal block, which is very convenient
8. There are 4 fixing bolt holes, the hole is 3.1mm
Tip: If the function of this product cannot meet your needs, you can contact us to customize it for you. Go to contact us for contact details.
Module interface
- DC+: connect to the positive pole of the power supply (voltage according to the requirements of the relay)
- DC-: connect to the negative pole of the power supply
- IN: The relay can be controlled at low levenl to pull in
- VCC external 3V
- GND External GND
Relay output
1.NO: The relay is normally open interface, the relay is suspended before it is closed, and it is short-circuited with COM after it is closed.
2. COM: relay common interface
3.NC: Relay normally closed interface, short-circuit with COM before the relay is pulled in, and vacant after the pull-in
